Good Morning!
I hope y'all had a
great weekend:)
Today I'm going to
show you how to make my
Cutie Pie Flower Quilt
I had so much fun
making this quilt
using the leftover
cute little pies
from our sew along...
I hope you love it
as much as I do!
This was a fun tutorial to do
and I think its the first time
I've showed you how
to set blocks on point:)
If you have never made a quilt
with the blocks on
the diagonal like this...
No worries!
I promise that I will walk you
through it every step of the way:)
Let's get started!
So...
Last week I showed you how
to make these
Cutie Pie Flowers
using Sew Cherry 2 fabric:)
to go to that tutorial.
Now that your flower blocks
are finished...
let's make the quilt top!
***NOTE***
After appliqué...
I trimmed the stems even with the
corners at the bottom of each block.
First up is the sashing and squares:)
Cut 36 - 2" x 8 1/2" strips
I used 1/2 yards Yellow
Cut 24 - 2" squares
I used 3/4 yards of the red daisy
because I'm also using
this print for the binding:)
Lay out your blocks, sashing, squares and
sew together like this.
Then sew the sashing between
the blocks as well...
Press towards the sashing strips.
Make sure that when you
lay your blocks out ...
you lay them on their
side going the same direction:)
Now to cut the side triangles!
From the background fabric:
(I used about 1/2 yards for the triangles)
Cut 2 - 15" squares
Cut them twice from corner to corner
like this for a total of 8 side triangles.
***Cutting this way is super important
so that the sides of the quilt
will not end up on the bias.
Now cut 2 - 9" squares
and cut in half from corner to corner
like this for a total of
4 triangles for each corner.
I sewed the sashing
and squares strips
on the top and the bottom
of the
center row first.
I did the top section first.
I took a photo of the
bottom section layout
before I sewed it together
to show you how I did it.
Keep in mind
that you add the side triangles
last just like you see in the photo:)
Press seams towards the sashing and triangles.
The triangles are cut
just a little larger
than needed so that we can
trim them down:)
Now that the side triangles
are on the bottom two rows...
you can sew that section together
just like the top section:)
Now sew the top and bottom
sections to the center row...
And turn it so that the
flowers are right side up.
YaY!
That wasn't as hard as you
thought it was going to be
...right?
I'm so proud of you:)
I love the way that these
look on the diagonal:)
Before we add the corner triangles...
trim the excess even
with the sashing like this.
Repeat on the remaining 3 corners.
Now pin the corner
triangles on like this...
Start by lining up the centers first.
Keep in mind that all
seam allowances are
1/4" just like always:)
Press towards the triangles.
Now to trim a bit off to square it up!
Use the 16 1/2" Trim-It Ruler
that we used for the Pie Blocks
during the
We will trim the corners first.
Simply lay the ruler
so that the aqua 1/4"
is almost touching the
corners of the red squares
on both the right side...
like this...
and along the top like this.
First...just trim the
corner of the quilt
just past the
red squares like this.
Repeat this step for the
remaining 3 corners.
Now you can trim the sides
of the quilt by laying the ruler
So that again...
the aqua 1/4"on the side
almost touches the
corners of the red squares.
Continue all the way
around the quilt.
All trimmed up and ready for borders!
Sometimes knowing how long to
cut borders
for a quilt set on the diagonal
can be a little tricky.
You can easily measure
the length of your quilt
from the center both ways to see
how long to cut your borders.
Add 1/2" to your measurement.
(keep in mind it will be square)
If you followed all of my step exactly
and used an accurate 1/4" seam allowance...
you will be just fine to cut
your borders the same as mine:)
For the borders...
I auditioned different bolts
of Sew Cherry 2 fabrics.
I realized that literally any of the
prints will be great...
but I ended up going with my
very first choice
that I already
had in mind
when I drew up the quilt:)
The red gingham!
I cut my borders lengthwise
because I didn't want to piece them.
I cut 2 - 6 1/2" x 42 1/2"...
and sewed to the sides like this.
The other 2 borders are
6 1/2" x 54 1/2"
for the top and the bottom.
#CutiePieFlowerQuilt
54" x 54"
As you probably know by now...
I love square quilts:)
This is a great size
to hang on the wall...
use as a table topper...
over the back of a sofa or chair...
or a super cute crib quilt!
I'll be sending my top
to the quilters this week
and I'll show you
when its finished:)
xx
Lori
4 comments:
So cute! And thank you for the wonderful tutorial!
Well, that is just adorable. I love the fresh, springy fabrics you chose. Nice job.
The cutie pie flower quilt is so pretty. Thank you for the way you use pictures and script so well in your tutorial. It makes things that you thought you couldn't do, do able. Your photography is awesome. Thank you for helping and motivating this new quilter.
Love your step by step tutorial, Lori! I love on point block layouts, but always seem to get turned around when doing them. You have a wonderful way of explaining and showing how it is done - thank you! I love your Cutie Pie Flower Quilt - and really enjoyed finishing mine - double thanks :)!
Post a Comment